Hewlett Packard HP-UX and Itanium

*** Upgrading to Release 4.2  from Release 4.1.x or earlier requires installation of all of the files listed below. It is not sufficient to update just executables and linkables. As with all new software releases, it is recommended practice to install, run, and thoroughly test the new release in a test environment, before replacing your current live system. And, of course, complete backups prior to any software upgrade are always a good idea.

Please note that there are a few additional steps that must be performed after installing APPX 4.2.x. Refer to the Installation Instructions for details.

Special Installation Note: If upgrading to this release from APPX 4.2.7 or earlier releases, the installer must scratch two files:

• $APPXPATH/0SA/Data/PRINTER.key
• $APPXPATH/0SA/Struct/PRINTER.dat

(Be sure to note the different paths to the files!) The installer should then run APPX and go to System Admin File Management and run create files to create a new key file for the PRINTER file.

	Release Notes	Recommended
	Installation Instructions	Recommended
	Unix Install Script	Recommended	12.0KB
	Common Unix Files	Required	31.4KB
	Risc Data Files	Required	21.0MB
Select the Executables or Linkables for the processor you are using, either PA Risc (on HP 9000 series) or Itanium.
	HP PA Risc Executables	Required	1.8MB
	HP PA Risc Linkables	Optional	5.0MB
	HP Itanium Executables	Required	3.7MB
	HP Itanium Linkables	Optional	3.3MB